Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG Midget and Sprite Technical - Another Technical Problem (NMC)
| I decided to do the CV joint boots on the Rover 25 today. According to Mr Haynes, you need to release the lower knuckle joint from the hub, in order to remove the driveshaft. However, it would appear that you need to remove the driveshaft before the nut will come off the knuckle joint. What am I missing?
|
| Dave O'Neill 2 |
| A big joint cracking fork or joint cracking tool should release the arm from the socket then you can lever it down, unscrewing the nut as you go ? |
| Tim C |
| Is it a MacPherson strut arrangement? If so, then spring compressors on it would lift the hub carrier up off the lower wishbone arm and give you the clearance you need to extract the nut. Tim's pickle fork advice is good but the lower arm will also be held up by the ARB so will remain under upwards tension. Have you slackened the driveshaft nut? You need to do that before releasing the bottom arm or there is nothing to work against. |
| GuyW |
| ARB link is removed and driveshaft nut is slackened. The problem is, the locknut is still stiff and if I do manage to separate the joint, I’m worried that I then won’t be able to continue undoing the nut. I can probably use a pickle fork, although that’s likely to damage the boot. If replacements aren’t available, it will mean a new bottom arm. I’m now considering removing the bottom arm, which only has one through bolt. |
| Dave O'Neill 2 |
| You are right to be cautious, it's a PITA if the joint starts spinning with the nut still on.
Have you removed the big outer nut from the hub end? You might find the joint will push inboard on its spines enough to allow the ball joint nut to come off. Once you have the ball joint nut off then other less destructive types of splitter exist, I have a clamp type and a hinged one. There is also the two big hammers method which works well if you have enough space to swing them. Also, is there a split in your ball joint gaiter, or is that just the photo? |
| AdrianR |
| I gave up on the ball joint and unbolted the inboard end of the bottom arm. |
| Dave O'Neill 2 |
This thread was discussed on 26/09/2026
MG Midget and Sprite Technical index
This thread is from the archives. Join the live MG Midget and Sprite Technical BBS now