Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG Midget and Sprite Technical - CV Joint Puller (NMC)
| It seems a little quiet here today, so I thought I'd introduce an NMC post. I need to replace the outer CV joint gaiters on the little Rover, but don't really want to remove the drive shafts. I was considering using a cone tool for stretching the boot over the joint, but then I came across a CV joint puller and wondered if anyone had used one. It looks interesting and not a lot of cash. What do you all think? https://www.ebay.co.uk/itm/305381006971
|
| Dave O'Neill 2 |
| Personal choice--I find it much easier to pull the shaft out complete, dismantle the inner joint which has straight channels and just pull apart by hand (some have an outer circlip to remove, some don't) then remove the shaft circlip that holds the inner joint spider/hub on the shaft and remove the spider/hub from the shaft--beware most(not all) of the spiders are offset/handed and will only fit back on properly one way round, then remove both boots.
Wash it all up, regrease the outer joint, fit the outer boot, slide the inner boot onto the shaft, refit the spider and reassemble the inner joint and grease then fit the inner boot.----done Also---do one axle , refit it then do the other,'don't' remove both axles at the same time-----Some transaxles don't have spigots on the backs of the side gears, so with both axles out the side gears can rotate on these and the gears drop into the bottom of the box--great fun---one at a time is safest way to attack it. willy |
| William Revit |
| I'd never heard of them, the only time (so far) I have needed to replace cv joint boots was on a Honda Civic, looked into getting the boots from Honda and found they cost £45 each, so got complete new driveshafts from here - https://www.jandrcvjoints.co.uk/ for half the cost of a single boot !! Collected the shafts from their place in Brum Shafts are going great 5 years later ! |
| Malc Gilliver |
| Wow, Malc. Their prices look amazing. |
| Dave O'Neill 2 |
| TBH they looked TOO good, but five years later the shafts are fine. They had loads of containers of brand new drive shafts - all made in China, but they look good. I kept the OEM Honda shafts just in case - used the boxes the new ones came from J and R and put them on a shelf in the shed ! |
| Malc Gilliver |
| Just for completeness, I can report that I purchased the CV joint puller for a mere £5.99 and it performed its task faultlessly. The job itself was a nightmare, as mentioned in my other thread, but when I installed the puller, I turned the nut by hand, with a socket, and it just popped apart. |
| Dave O'Neill 2 |
| Good to hear |
| Malc Gilliver |
This thread was discussed between 07/09/2026 and 27/09/2026
MG Midget and Sprite Technical index
This thread is from the archives. Join the live MG Midget and Sprite Technical BBS now