Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGB Technical - Correct Ignition Coil ?
| Hi Everyone. I have just purchased from Moss a new coil for an early rubbernose roadster. I believe that this should be 6V and not ballasted as this is in the wiring harness. I have received a coil that has printed on it '12 VOLT BALLAST'. I contacted Moss and was told that this was the correct coil. Original part No GCL111 superceded by part No GCL132. Not knowing very much about this subject, could anyone tell me if this coil is O.K or not. Thanks, Chris. |
| Chris82 |
| I think it may be a matter of terminology. The standard description, I believe, would be "12V coil for a ballast system"- which is what Moss provided. Technically, it probably is a 6V coil that can be used on a 12V system with a ballast resistor(or as in your case, a ballast resistance wire). |
| CD Dewey |
| Chris. My thoughts are the same as those expressed by CD. A quick check is to install an ohm meter across the two LT terminals of the coil. Resistance should be about 1.62 ohms for a coil designed to be fed an operating voltage of 6-8 volts. Les |
| Les Bengtson |
| Hi, The resistance across the terminals is approx 1.4 ohms. Can i then assume that it is a 6V coil and be the correct one for my B? Thanks for your input. Chris. |
| Chris82 |
| Yes, Chris. This sounds like the correct coil. The coils designed to run a full 12V input have about 3.6 ohms resistance. Yours should do fine. Les |
| Les Bengtson |
| Les, CD. Many thanks for the info. Chris. |
| Chris82 |
| I'd concur with the conclusions, also that manufacturers labelling of these coils tends to be rubbish! |
| Paul Hunt 2 |
| Hi again, I fitted the new 6V coil this afternoon and although everything is O.K, i had to turn the idle speed up slightly to get it to idle properly. Has anyone got any thoughts on this? Thanks, Chris. |
| Chris82 |
| Have you checked the timing hasn't altered? It shouldn't if all you did was swap the coil. Different coils should really make any noticeable difference at idle unless there is something really wrong with them. |
| Paul Hunt 2 |
| Paul, All i did was swap the coil from the old 1.2 ohms (tested) to the new 1.4 ohms (tested).The only reason i put the new one on was because i have fitted the 123 ignition and it was recommended by the manufacturers. After turning up the idle screws about half a turn she runs fine. I thought it a bit odd and not knowing much about auto electrics i thought i would give it to you guys who are very knowledgable in this field. Thanks for your interest. Chris. |
| Chris82 |
| Half a turn *is* quite a bit, I'd expect an increase of several hundred rpm for that. |
| Paul Hunt 2 |
This thread was discussed between 23/01/2007 and 26/01/2007
MG MGB Technical index
This thread is from the archives. Join the live MG MGB Technical BBS now