Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGB Technical - Correct steering column/engine?
| I have a 1972 Roadster (GHN5/265464G) with a non-collapsible steering column. Now Clausager says that the 1972 model build (from 258001 on) used collapsible columns on non North American cars. Do I read this as all cars other than North American, or all export cars other than North American, therefore leaving a chance of UK ones fitted as mine? The car also has a reconditioned 18GG engine instead of the 18V that should be there. Garage receipts claim a BHM1111 was fitted but as I understand it this would mean a gold seal 18V. Any ideas, apart from a dodgey receipt? |
| Richard Coombs |
| Beats me, but I can tell you that I have shipped GEM steering column bushing kits to folks in England, Germany and New Zealand. All these customers had collapsable columns in their cars, just like the ones used in the NA spec cars with no complaints. I wonder if the non-collapsabel columns use the same basic design but without the perforated outer tubes |
| gerry masterman |
| Richard, LHD cars were fitted with a coolapsible steering column for exports only in this period. The 18V was a compromise to the Marina 1800 production and some internal items of the 18V are different to the 18GB to 18GG engines, making produktion of the 18V cheaper. As long as no new followers, pushrods and timing gear items have to be replaced, it does not make any strange differnce as these spares are a little more expensive as those fitted to the 18V. Ralph |
| Ralph |
| Thanks for the thoughts guys. Gerry, the fundamental difference between the columns is that the non-collapsible is literally a straight and very solid bar inside a tube. The collapsible column is a series of 'stepped' sections which, hopefully, collapse, one inside the other. The bushes are also different. Interestingly, the lower support bracket on my car is the one used for the collapsible column. The shapes are quite different. Quite a puzzle, but that's the joy!! Ralph, the 18GG is indeed an ok engine and, as it's only ~32Km 'old', I am hoping I shall not have to worry about a rebuild for some time. The garage that did the exchange left everything else as for the original 18V, including the water pump and pulley, and the AUD492 carbs with their sprung needles. I am about to replace the carbs as they are badly worn and shall probably go for a set which are more suited to an 18GG. Regards Richard |
| Richard Coombs |
| There were two types of collapsible column used in UK-spec cars - a 'slimline' one from the start of the 72 model year for the remainder of chrome bumper production. North American spec cars got a different design for the *67* model onwards. Rubber bumper cars all got the same column regardless of market. |
| Paul Hunt 2 |
| I know for fact that there are two different columns used on RB cars here in the US. The breakline seems to be 1977. The bearings, top and bottom are different in design, also requiring a differend turnsignal switch. I have made GEM bushing kits for both. Bearings are of a better quality in the 77-on versions as well |
| gerry masterman |
This thread was discussed between 23/01/2007 and 25/01/2007
MG MGB Technical index
This thread is from the archives. Join the live MG MGB Technical BBS now