MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGB Technical - draining coolant from block

Hello, A few months ago I bought a 1980 B, proceeded to dissasemble all peripheral engine parts to replace gaskets, hoses, and just about everything wear dated. Draining the radiator was straight forward but finding the drain to empty block is not clear. There is a bolt just above the starter and 2 inches or so rear of the distributor. Could this be it and if it is every wrench or socket I own won't fit snuggly metric, standard, even whitworth, of course the only size I don't have is 18 MM. Am I on the right track?
Thanks Gary L. Emes
gary emes

Gary-
Yes, that is the drain plug for the block and yes, it takes an 18 MM socket. I recently had to drain the system on my '79 B. Nothing came out after removing the plug. Stuck a screwdriver in the hole and started to remove a bunch of black looking crud. Still could not get any liquid to drain...and the block was supposed to have been hot tanked prior to a rebuild. I have another spare engine that was also rebuilt and tanked and that drain plug/hole is also plugged with crud.

Larry
Larry Youngblood

Gary, That's the one. I think I have been using a 6 point 3/4" socket, I tried an 18mm and it is a very good fit, I know, it isn't supposed to be metric but it fits.

Don't be surprised if you find the area under the plug dry. I have opened up three different MGB blocks and all were dry behind the plug. When I rebuilt two engines, hot tanking didn't clear the block. I used a long screw driver on the block through the rear water jackets to clean the passages, must have removed a 1/2 cup of crud. You may have some luck working through the plug with a coat hanger or some other stiff wire, I didn't. After my rebuild I used distilled water with my coolant and a year later when I changed the coolant it was dry behind the plug again. It doesn't seem to do any harm but it's frustrating.

Clifton
Clifton Gordon

Gary,
Some years back, I purchased a brass drain plug that had a small drain valve built in. I think I got it from Moss. It really makes it easy to drain the engine. I do it rather often (about every other year) and never had a dry area behind the plug. It always flushed out perfectly.

Don
Donald E. Elliott

The coolant drain plug in the block is a 1/4 British Standard Pipe thread and the head takes a 3/8 Whitworth (or 5/16 BSF) wrench. Cheers - Dave
David DuBois

Thanks fellows I'm on it and it should be interesting what I'll find. On a TD owned a few years ago it had a beautiful little tap with shut off in easy access, things have changed.
Gary L. Emes- 79 on door but 80 B on title.
gary emes

Gary - I forgot to add to my post, the closest, across the flats size to a 3/8 Whitorth is the 18mm (0.001" smaller). 19mm is 0.048" larger and 3/4" is 0.050" larger. Cheers - Dave
David DuBois

This thread was discussed between 14/01/2007 and 15/01/2007

MG MGB Technical index

This thread is from the archives. Join the live MG MGB Technical BBS now