Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGB Technical - Early head on a 73 block
The head is an early large combustion chamber version. I had the large intake valves from a big valve head installed along with new guides and seats and the head was decked .010. I am using the rockers and the short lifters and long push rods that were in the 73 block also there was a Kent 714 cam that looked to be almost new. The block has the shallow dished pistons 6.2 cc and has been bored .030 over. When fitting the head to the bock to check the valve cleance I had to screw the adjustment screws all the way in order for the rockers to make contact with the valves and push rods. I know this is not right. I have measured the height of the early head and the big valve head (cracked) and the difference is .054, but there must be something else that is making this problem any help or info would be great, thanks Steve. |
| SWS Stephens |
| I have this same problem, don't know if I need longer pushrods or just longer adjustment screws. I haven't found any longer screws listed in any vendors catalogs. I was told MiniMania carried them but they never returned my call. Any help would be appreciated. |
| LuvMyMG. |
| Hmmm...maybe it's the rocker shaft pedestal height? Just a shot in the dark - as I am not aware of any differences in height over the years. |
| Daniel Wong |
| it doesnt have the diff cam followers in does it bucket type are better but need a longer push rod as it sits inside the follower so maybe it has bucket cam followers in and yo have the wrong rods for them? ste |
| Ste Brown |
| It is quite a common problem with some reground cam profiles sold. Normally there is nothing wrong with the duration and lift BUT it is an repro item ground from an existing cam, not from a blank, so the diam of the ground circle of the cam has become smaller and extreme fast wear on the rockers and guides will occure with these cams. It is not a problem coming from the followers or pushrods, although adjustable pushrods made for other engines would cure it. Dough Johnson (mgamgb.com) has given some information upon what can been done here. I had the problem with the adjuster screws on the rockers too and had to fit a new cam, followers and guides only a few thousand kilometers later. The now used Piper cam from a blank is a joy compared to the reground one it replaces. Ralph |
| Ralph |
| Ralph has the correct answer. It's in reground cams, they have to remove too much material to make the desired profile. The problem will also affect the valve train geometry. Clifton |
| Clifton Gordon |
| As Clifton noted, Ralph has the correct answer. This problem can be dealt with by using longer pushrods. This will bring the valve train geometry back to where it ought to be. I've had excellent results (and prices) from a little cam place in California called "Norris Performance Products". He can make chrome molly (molybdenum) tubular pushrods to ANY length you want. A side benefit is the pushrods are significantly lighter (equals less wear)and are stronger to boot (less flex). About $4-5 each IIRC. I have no interest in Norris other than being a satisfied customer for over 2 decades. Norris Performance Products 14762 Calvert St. P.O. Box 484 Van Nuys, CA 91411 (818)780-1102 Tom |
| Tom Sotomayor |
| Thanks for the info, Tom thanks for the contact info for Norris looks like that may be the way to go at this point. |
| SWS Stephens |
| Thanks guys. |
| LuvMyMG. |
This thread was discussed between 23/01/2007 and 24/01/2007
MG MGB Technical index
This thread is from the archives. Join the live MG MGB Technical BBS now