Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGB Technical - Gearbox mounts 3 sync pull handle
I have to replace the mounts on a very early car - they have perished from 40 years of oil leaks and it has failed on that for its 5-yearly safety check. Are there any tips to doing this with the gearbox and engine in place. I have a well equipped workshop, and can also get access to a pit or lift if that makes it any easier. |
dominic clancy |
Does the car have overdrive? This can make all the difference as the od unit is a bear to work around. The way around this problem is to drill a hole on each side of the crossmember that allows you to gain access to the gearbox mounts. RAY |
rjm RAY |
Yes, it does have OD |
dominic clancy |
Dominic - E-mail me at SUfuelpumps@donobi.net and I'll send you instructions on modifying the cross member to simplify installation of the mounts. Cheers - Dave |
David DuBois |
David to the rescue again. RAY |
rjm RAY |
Thanks, now I have the tricks that I knew would be there for the asking. |
dominic clancy |
This thread was discussed between 03/05/2010 and 04/05/2010
MG MGB Technical index
This thread is from the archives. Join the live MG MGB Technical BBS now