Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGB Technical - Limited Slip Diff
| Has anyone had much experience with LSD's? I am considering fitting a new diff with a higher ratio to reduce my speed in gears, and am considering putting in a LSD while I am there! Can anyone tell me what is available, and if they make that much difference? I am now that much of a maniac, but do enjoy a little sideways action now and then, so hoping this will make things a little smoother!?!? |
| Ed Braclik |
I like my LSD a lot... although I think it would provide less benefit on a 4-cylinder MG. It's not worth the money, unless, it just makes you happy! There should be several articles on differentials in back-issues of The British V8 Newsletter. The searchable archive is here: http://www.britishv8.org/British-V8-Back-Issues.htm If you read through our old "How It Was Done" articles you'll see that most of our V8-converted MGB's are running non-stock axles or ratios. You can take a census of axle/LSD types and gear ratios. On your side of the pond it may be cost-effective to upgrade the MGB axle... but here in the colonies the combined cost of a Quaife plus new gears are higher than the cost of replacing the whole axle with something more robust. There's one outfit here in the states that offers a factory-new narrowed Chevy S10 axle as a bolt-in replacement for the MGB axle for about 1350 USD (with LSD and customer's choice of 3.08, 3.42, or 3.73 gears). A narrowed junkyard axle should be cheaper than that. I've got about 1000 USD tied up in my 8.8 Ford, with 3.27 gear and a "Traction-Lok". If I had it to do over, I'd probably use a Ford 8-inch to save some money and weight... but 8.8 axles were easy to find with low mileage when I was in the market. Of course, you'd probably need a new driveshaft (figure 250 USD). The hardest part of the whole axle swap is getting the parking brake to work well. |
| Curtis Jacobson |
| Ed might have a 4-pot, but for clarification, it's a twin-cam VVC unit putting out in excess of 180bhp through the Ford type 9 5spd box. |
| Martin ZT |
| The LSD was stock on the RV8's and should work well in this setup. Maybe the RV8 fellows can quote their experince here. |
| Ralph |
| Ed- I have a Quaife limited slip differential in my MGB. It allows me to get on the power earlier when coming out of a mountain curve. Best of all, being a torque-biasing type, it transfers the power from the wheel that slips to the wheel that grips. |
| Steve S. |
| Ed, unless you are experiencing lifting the inside rear tire on hard cornering I doubt if you'd notice much improvement from a limited slip diff. You would notice an improvement in directional stability when accelerating on wet or slick surfaces. The Quaife type diffs are very smooth in action, some plate type limited slip units can be 'grabby' as they engage and disengage. I generally like having limited slip diffs, but the cost of some like the Quaife is pretty high and I'm not sure if it would be worth the expense unless you really have a need. I think that if your rear suspension isn't already modified to reduce axle tramp, you'll get more results for the money by adding locating bars and a panhard rod than a Quaife. |
| Bill Young |
| If you try pulling out of a junction in the wet with an LSD you can usually end up back in it again! (Frightened me witless once 20 years ago with a V12 Jaguar, now I know wet road=don't push pedal hard)) The LSD lets you spin both wheels at once, and the back of the car trys to overtake the front. Probably won't matter much with a low power/torque engine like the 4 cylinder, but might be entertaining with a 185BHP V8. |
| Martin Layton |
| Guys Appreciate your help on this one, seems like there is a lot of research ant trial for me to do! I currently have a Panhard fitted along with a lot of improvement to the front and rear end. It does ride amazingly well for a B, but get on the power too early and the back is spinning and power is gone! I now have just shy of 200BHP from my engine running throttle bodies, Emerald ECU, DVA top end etc, etc and I am missing exiting from corners and roundabouts without getting some opposite lock in.... Amy one else with knowledge of this would as always be appreciated! Also looking to change to a 4.2 diff to bring my gearing down as I am currently hitting 100 MPH before I hit the rev limiter in 3rd.... |
| Ed Braclik |
| Ed, Interesting topic. I've been looking into this as well, and am currently in contact with some people who have one (one of them has a PhantomGrip). I'll post whatever I can find! Alex |
| Alexander M |
This thread was discussed between 22/01/2007 and 23/01/2007
MG MGB Technical index
This thread is from the archives. Join the live MG MGB Technical BBS now