Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGB Technical - Loose nut for choke pull
Hello all. The choke pull on my '71 B came loose. I can't seem to reach it from under, does this require taking the dash off? |
Napoleon |
I managed to do it without removing the dash (with difficulty). The nut will have slid along the cable and should be easily recoverable. I think I used a wooden wedge to ease things apart enough to reconnect things again. |
Geoff Everitt |
I tried for 10 minutes and could not get my hand in there. Now I know that it CAN be done without taking out the dash I will try until I succeed. Thanks. |
NV Valera |
I used a tube spanner (wrench).I cut a slot lengthwise down the spanner wide enough to pass over the cable & then slid it back to locate the nut. In my case it was a sparkplug spanner supplied with a lawnmower. The car is a '78 ,it might be a different size nut on a '71 but the same method should still work. Barrie E |
Barrie Egerton |
I would remove the tachometer and then you can reach right in. Sandy |
conrad sanders |
Don't you hate it when someone comes up with a simple suggestion. Even more when it works, thanks Conrad. Ric |
RIC LLOYD |
I have never taken out the tach but I assume it's easier than trying to reach in there. Thanks for the suggestions. -N |
NV Valera |
This thread was discussed between 05/08/2008 and 06/08/2008
MG MGB Technical index
This thread is from the archives. Join the live MG MGB Technical BBS now