Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGF Technical - alarm !
Can anyone help me with my alarm problem? I had to remove the fuse from the alarm/central locking system and now everytime I lock the carwith the fob the alarm goes off. Anyone help me????? |
tony |
why did you have to remove the fuse? |
A SWAN |
I have recently bought the car and the previous owner didnt really maintain it very well. A lot of fuses, bulbs etc had gone so I was just going through them all. Foolishly I removed the alarm fuse before I realised what I had done. |
tony |
well am sure if you put in the correct size of fuse it should all return to normal and work fine. Andy |
A SWAN |
I have replaced the fuse and the remote central locking and immobiliser are working but the alarm just goes off straight away! |
tony |
Tony - I recently had to replace my dead battery. Upon reconnecting the new battery I had problems resetting the alarm. May be similar to yours. Try as the owners manual states - press the handset LOCK button four times in quick succession, then press the UNLOCK button once. Best of luck |
Tony Devine |
Thanks Tony, I haven't got an owners manual yet I have just ordered a new one. I will try your suggestion, thanks for your help. Tony. |
tony |
i had same problem with my 98 v v c it drove me mad two different auto elictrcians looked at it but could not find fault in despiration i took off drivers door trim (1st place to check)pulled out door catch mechanism an found the black (earth) wire to be snapped in the block where it connects , therefore making an intermittent conection i soldered a wire in bypassing the block and not had a problem since (2 yrs)hope this is of some help regards richard |
richard |
I had similar problems after disconnecting the battery to work on the radio - same as you Tony, alarm kept going off every time I locked it. First thing I did was to disconnect the horns to pacify the neighbours - then a trip to Brown & Gammons who checked it over with Testbook (the MG Rover diagnostic program). If suggestions on here don't work you may have to find a local dealer or specialist with Testbook and get them to have a look (or contact a decent auto electrician). Once B&G cleared the alarm fault codes and re-synched the fob all was fine (touch wood... I think I may have shorted something when fiddling with the radio...) Will |
Will Harvey |
This thread was discussed on 23/01/2006
MG MGF Technical index
This thread is from the archives. Join the live MG MGF Technical BBS now