MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGF Technical - Alarm goes off when opening the boot ?

My alarm goes of when I open the car boot and the alarm is set. Is this correct as it never used to go off.
Steve

I would also like to know the answer to this question, as I want to test my alarm to see if it works fully.
Wez

I had this problem a few months ago, it was caused by a damaged cable loom, check the wires from where they leave the boot lid and join the more wire in the engin bay (Left hand side). If you remove some of the black tape you may find like I did that some of the wires have snaped. If they have its a simple job of pulling back some of the slack and crimping the end together. You may also find that your rear stop lights also not working if thats also fitted.

Hope that helps.

Mark
Mark

Opening the boot should not activate the alarm. However, opening the bonnet should (although if you have a poor electrical contact at the bonnet mounted microswitch, the alarm may fail to trigger).

HTH
Rob Bell

There is a boot switch and a boot key switch. I believe the boot key switch must operate before the boot actually opens so if the boot switch operates early or the key switch operates late then the alarm will trigger. The boot switch is mounted in the centre behind the catch on the boot lid and the key switch is obviously mounted behind the boot keyhole.
Check out the operation of these with the alarm unset. There is a pull cable running from the key to the catch. It may need adjusting. Also, as mentioned before, there have been problems with the wiring loom in the boot chafing as it runs past the LH hinge and into the engine compartment.

HTH

Bruce
Bruce Caldwell

I would like my alarm to go off if set, when the boot is opened. How do you do this? Paul...
PAUL HINDLE

If you look clostly behind the barrel lock in the boot you will see a microswitch, this is depressed when the lock is turned. To disable the disabling pull one of the spade connectors off the microswitch.
Job done

Will
Will Munns

This can also be a problem if you have a faulty drivers door lock. Check that the barrel has not twisted in its seating within the door handle. On mine the barrel is slightly offset to the right i.e with the key in, the key is not vertical.

Gaz
Gaz

Gaz, this shouldn't cause the problems as the microswitchs in the door are actually in the door catch, if you are getting this then it might be time to take apart the door and to adjust* the metel bar that connects the lock barrel to the door catch.

Will
* there is no adjustment as such, but the metal bar has an angle bent in it, and incressing the angle will effectavly shorten the bar, decresse and it gets longer!
Will Munns

This thread was discussed between 05/03/2002 and 07/03/2002

MG MGF Technical index

This thread is from the archives. Join the live MG MGF Technical BBS now