MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGF Technical - Bush question....

Just out of interest... what other poly bushes do you think could I fit myself? instead of taking it to MGFC, MGOC or B&G....

As some of you will know I've just done the shocks and tie-bar bushes myself and now plan to do the rest of the poly bushes but know some are beyond my capability a bit :-)

Also, is there anything else under there suspension-wise that I should look at changing to give the car a more "solid" feel...

Cheers

Chris
Chris Tromans

I've got some pages online about bushes that were easily installed. The most special tool we used was the torque wrench.

http://www.mgtf.be/MO_TU_SU_Polybushes_01.html

I've got the idea that I will need to use my hydragas pump to change the bushes at the front.
Erik

Erik,

Many many thanks... that is a cracking set of pages!!

I might order a few more then and set a few hours aside for a few evenings :-)

Cheers

Chris.
Chris Tromans

Hi Chris,

The front wishbone bushes are probably the trickiest, as the suspension assembly above needs to be supported by means of a wooden wedge, and the wedges I've tried thus far have been unceremoniously crushed 8-( Lopping a leg off the mahogony table could well be the answer...

Rob speaks highly of swapping the subframe mounts for solid ones, but I'm leaving those until winter when the car is garaged, or until the engine goes pop.

The remainder of the poly bushes are all less involved than the tie-bar bushes, so you're unlikely to struggle much. If I perfect the wedge design & spec, I'll let you know.
Mike Hankin

hi ,i really need to replace the bushes on my car ,any idea where you can get replacement ones,cheers,cliff
C.S COLLINGS

The problem I had with the rear bushes on the lower arm (inner and outer)wasn't fitting the new poly bushes it was removing the old ones. I used a hot air gun to virtually burn them out. Then I had to sand blast the holes in the arm to get rid of the corrosion before fitting the new bushes.
Ken Waring

Mike,
wooden wedges are far too dangerous as they breakup. (as you know).
Use a piece of aluminium or steel. That will do the trick. You don't actually need a wedge shape as such and IMO it is safer to use a flat piece. I had to do this when I changed my clutch. http://www.mgfcar.de/gearbox/clutch_replacement_MGF.htm

Another tip is to smear any new bushes with a bit of dishwashing liquid to make it easy to press in. The dishwashing liquid does not attack the bushes, unlike grease oil etc.

PS. Erik, nice pics.

Cheers,
Branko.
Branko

The critical items are the front wishbone bushes, if they are not correctly installed AND lubricated (use copperslip type grease, not anything that will wash out) they will overstress the metal and cause them to snap...not nice!
mike

Mike,

Many thanks for your input.. I think those are the ones I won't be doing myself :-) I'll give the ARB ones a go and the droplink ones then I think I'll go to the professionals like yourself for the rest :-)

Cheers

Chris
Chris Tromans

This thread was discussed between 25/07/2005 and 26/07/2005

MG MGF Technical index

This thread is from the archives. Join the live MG MGF Technical BBS now