Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG MGF Technical - Idle Speed shake ??
after just start in morning, My idle speed "sometime" is under 850 and shaking . Or after I driver very long , I shifted gears and stepped on clutch. My idle speed was under 850 and shaking . I cleaned stepper motor and modified alloy throttle. I modified alloy throttle becasue My idle speed was high(1300-1500) after driving very long . after I connect to diagnosis computer, My alloy throttle was normal . after I checked very place near engine, they were normal . Why?? WHY?? |
KUO yuan-hsin |
Who Can tell me the Question ? |
KUO yuan-hsin |
Turn on ignition but don't start engine. Push throttle to the floor five times within 7 seconds or so. Turn off ignition. Throttle calibration should be reset. HTH |
Bruce Caldwell |
Thank you. I has tried it ,But be no efficacy. Why ? |
KUO yuan-hsin |
Help me !!!!!! I use the ways with the homepage . http://www.mgf.ultimatemg.com/group2/Throttle_body/index.htm But the all ways are no efficacy. My car has connected to diagnosis computer ,And No any troubles. My throttle has changed to alloy throttle body . I has no any ways to the 1200-1300rpm range. The 1200-1300rpm range problem sometimes occur. Why ?? |
KUO yuan-hsin |
Check the gaps of the ignition plugs and set to minimum gap. Check comoression of each cylinder. It is possibly a misfire in one cylinder. |
Bruce Caldwell |
"Check comoression of each cylinder. It is possibly a misfire in one cylinder" If My car have the state , My car will very shake and no smooth . The gaps of the ignition plugs is new , and ignition also new. My engine had repaired lately. |
KUO yuan-hsin |
This thread was discussed between 09/01/2008 and 26/01/2008
MG MGF Technical index
This thread is from the archives. Join the live MG MGF Technical BBS now