MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGF Technical - MGF brakes

Can anyone tell me the procedure for adjusting the brake pedal on a 1996 vvc. The pedal is slighty loose and resting on the brake light sensor. This is not good as everyone thinks I drive with my brakes on all the time. Any help would be much appreciated.

Cheers Tom
Tom

Not sure why the brake pedal is loose Tom, but the brake light issue is readily rectified. Copied and pasted from the MGF FAQ:

>>
Brake Lights

Problem:- Rapid or sudden application and release of the brake pedal (Emergency stop, autotesting etc) causes the ratchet mechanism in the brake light switch to close up a notch or two, causing the brake lights to be sensitive to bumps or, at worst, on all the time.

The solution is to reset the ratchet as discussed below

The switch is situated under the dash, just above and behind the pivot point of the brake pedal. It is a pig to get at and is released by twisting (if I remember correctly). The ratchet can also be reset by depressing the brake pedal and at the same time pulling the plunger on the switch out.

All you need to do is either remove the switch or while you have your head in the footwell, give the plunger of the switch a VERY hard tug. This pulls the ratchet out and the next operation of the pedal sets the switch clearance up.

If the above fails to work then there is a MG technical bulletin on the same problem,
it seems MG have designed a new switch, the affected Range = All vehicles upto VIN 036126

old part number = XKB 100080; new part number=XKB 10003

This is designed to fix the problem once and for all, the new switch is not self adjusting, but uses a set of washers held on with a nut to set the correct level.
<<
Rob Bell

Cheers Rob, I have already taken the switch out and freed up the moving parts which has helped a little. I will follow your advice and see what happens.
Once again thanks for your help
Tom
Tom

While Im on the subject of brakes has anyone had the problem of the handbrake cable becoming tight and not resting in the complete down position. Im pretty sure it is something to do with the rear brake caliber and assume there is a self adjusting mechanism located in the caliber that has worn,any advice would be welcome.
Cheers Tom
Tom

I think a lot of ppl have this me included, i havent bothered to look at it yet though :0)

Nick Walters

Symptoms of the mechanism in one caliper starting to sieze up, a fairly common thing at this time of year following a long wet period. The caliper design is fairly common and so this is something that is seen on many other cars, especially VW/Audi.

Rog
Roger Parker

This thread was discussed on 15/03/2002

MG MGF Technical index

This thread is from the archives. Join the live MG MGF Technical BBS now