MG-Cars.info

Welcome to our Site for MG, Triumph and Austin-Healey Car Information.

Recommendations

Parts

MG parts spares and accessories are available for MG T Series (TA, MG TB, MG TC, MG TD, MG TF), Magnette, MGA, Twin cam, MGB, MGBGT, MGC, MGC GT, MG Midget, Sprite and other MG models from British car spares company LBCarCo.

MG MGF Technical - MGF Engine Coil??

Morning

I have just found out my engine coil has gone on the F and not being technical type of person can someone tell me approx how much I will have to pay out to replace it?? and how serious it is??
Barry Shrimpton

Barry,
Is it a VVC or 1.8i ?

On the VVC there are two small coils and one bigger one on the 1.8i. Don't know the cost but I am sure someone will pop up with your answer.

Bruce
Bruce Caldwell

If the coil is on the way out then the engine will fail to fire cylinders, if you continue to do this then the cat will die. How do you know it's the coil?

Will
Will Munns

Local garage tell me it is the engine coil. Bruce it is a 1.8i S Reg.

Hope this helps

B
Barry Shrimpton

Any news anyone??
Barry Shrimpton

Barry, I had the coil on my P reg 1.8i fail late last year. I believe that the replacement coil was about £40 from MGR. Fitting is extra...

If you're fitting it yourself I would recommend replacing the HT leads at the same time, if you haven't replaced them recently. Don't get the leads from MGR though - they charge about £40 for a set. An equivalent set from a motor factor is £22 or you can get uprated ones from the likes of B&G, Mike Satur for about the same price as the MGR ones.

Ralph
Ralph

Thanks Ralph That is reassuring to say the least.

Barry

Barry Shrimpton

What were the symptoms of the coil going. Was it a total failure or did you get an occasional miss on cylinder firing ?
S Laithwaite

Mine was a total failure. The engine stopped after I had driven about a mile and would not restart. The RAC guy (when he finally turned up, 4 hours after I called them) diagnosed the problem as being the electonic ignition! I'm now with the AA, but haven't had to call them out yet - touch wood.

Ralph
Ralph

I just got the coils replaced on my VVC for about £120
james

I don't think it is a particularly difficult job to do yourself.
Tony Smith


Hi all,
would like to give some info about the VVC-coil as a friend here in Sweden who drives his 97-vvc all year round also have had a coil-failure some time ago. We looked at the coil and found the following: Due to the exposed placement of the VVC coils it is very likely that the laminated steel core starts to rust. This due to that the laminated portion is directly in the salt-spray from the road ! So what happends is that the rust forces the tight lamination apart and finally makes the coils worse and unable to generate a good enough spark and it can also make the plastic mould crack = water ingress. So if You have a VVC and drive it all year round do use Dinol or any other rust-preventer on that core to stop further decay.

Best Regards , Carl.
Carl

A phone call to a dealers parts dept and ask for a price on GCL 201. This is the coil for Non VVC MPi cars.

Rog
Roger Parker

This thread was discussed between 19/03/2002 and 24/03/2002

MG MGF Technical index

This thread is from the archives. Join the live MG MGF Technical BBS now