Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG TD TF 1500 - Jerking
Took the TF out for some sunshine this morning first time for a few weeks then it ran faultless but today at light pedal pressure (low speed) it started jerking, once I gave it more throttle the jerking stopped. Any clues Thanks George |
G Mills |
Pulling air instead of gas???? Running lean, overcome when running fast? Look for loose shafts in the carb bodies or loose/ bad gaskets. Spray carb cleaner, etc., on them while running. A change in revs will tell the tale. |
MAndrus |
Hi George, My TF 1250 did the same thing on our annual New Year's Day run. I put some fresh gas in it - high octane - and the jerking went away after about a mile. John |
John Mitchell |
I had this happen when oil level in the dashpots was low. |
G Evans |
I had this happen on new years day as well. But it wasn't the fault of the car. |
IW Martin |
Thanks for the input, changed the plugs and all is now good, Regards |
G Mills |
Weak distributor springs and you just happened to be at the rpm where the timing would vary. |
W. A. Chasser Jr |
New plugs will often seem to fix things when a condenser is on its way out. Part of a condenser's job it to fire the plugs efficiently, so the plugs stay clean. |
D mckellar |
Thanks for the reply's but I do hope the last two ideas are way off , my distributor has just been to Jeff for a total rebuild and setting etc. I will concede though that changing the plus may not be an end to the problem, I have been fiddling with the carbies , even though they were totally overhauled just before I got the car I don't think they are adjusted correctly and I am finding it hard to do that. Next weekend I will run it again and see how it goes. Regards George |
G Mills |
Up date: went for another run with new plugs, jerking started again but not so bad,my next thought was that it may be running a bit lean turned it back a bit and presto running beautiful again, this is my fault I play with the carby adjustment and not really know what I am doing I stuff it up. Regards george |
G Mills |
This thread was discussed between 17/01/2016 and 24/01/2016
MG TD TF 1500 index
This thread is from the archives. Join the live MG TD TF 1500 BBS now