Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
MG TD TF 1500 - Steering Rack Help
My workshop manual is at the machinist, and I am working on the steering rack. I installed the lock washers over the ball housing, not realizing what the two tabs on the lock washer were for. In screwing the tie rod assy into the steering rack. Now I see that there are two indentions on the rack apparently to receive the two tabs. Question is how do I get the lock washer on so that the steering rack will receive the two tabs and hold the lock washer in place? Does this question make sense?
![]() |
Bill Reid |
I searched the archives for STEERING RACK and found this link http://chicagolandmgclub.com/photos/a_rack/ It might help in your rebuild Steve |
SPW Wincze |
Thanks, Steve |
Bill Reid |
Oops......bad link |
Bill Reid |
Try to cut and paste it |
SPW Wincze |
It eventually leads to THE MGAGURU http://mgaguru.com/mgtech/steering/sr201.htm |
SPW Wincze |
This thread was discussed on 27/12/2016
MG TD TF 1500 index
This thread is from the archives. Join the live MG TD TF 1500 BBS now