Welcome to our Site for MG, Triumph and Austin-Healey Car Information.
Triumph TR6 - rear bumper assembly
Hi to all in BBS land. I'm almost done assembling the car and I have a question about the rubber joiners that go between the main bumper bar and the two side pieces. they look perfect until I tighten the bracket assemblies then they start to push out and lose their shape I've seen alot of 6's like this I was hoping with new rubber joiners and hardware I would have better results Any advice is really appreciated Regards John |
John O'Meara |
John When I did mine with new rubbers and bolts, I recall that one side did not fit well and was raised up...away from the bumper. That was back in 2001. Now they are both flush/flat with the bumper. Totally forgot about that little mess. I guess they must have shrunk a little. Maybe same for you??? Rick C |
Rick Crawford |
Hi Rick Thanks for replying. I took the ends off again put some loctite light on the threads and did'nt tighten as much They look alot better especially on top Thanks again for all your input and advice on this site. It's helped me throughout my restoration. See you at Bronte for sure! Regards John |
John O'Meara |
John As long as she looks good. For sure see you at Bronte. I probably have asked this before (CRS ya know), but where abouts in Ontario? Maybe you join our group going to Bronte. Rick C |
Rick Crawford |
Hey Rick I'm located in Hamilton Ontario about 20 minutes west of Bromte I'll probobly be looking for Bob Craske from Dundas come Bronte Day I'm installing my last tailight tommorrow; plates are already on so I should be taking a maiden voyage this weekend Regards John |
John O'Meara |
VROOOOM! Have fun and sovor the moment. Rick C |
Rick Crawford |
John I cant wait to see it...when are you bringing it over to the garage so i can ogle at it? bob |
Bob Craske |
This thread was discussed between 05/06/2006 and 10/06/2006
Triumph TR6 index